Search results
This service manual covers oil pumps and coolers for Fuller Heavy Duty Transmissions by Eaton Cummins.
- Proper Oil Level
- Draining Oil
- Refilling
Make sure oil is level with filler opening. Because you can reach oil with your finger does not mean oil is at the proper level. One inch of oil level is about one gallon of oil.
Drain transmission while oil is warm. To drain oil remove the drain plug at the bottom of the case. Clean the drain plug before reinstalling.
Clean case around filler plug and remove the plug from side of the case. Fill transmission to the level of the filler opening. If the transmission has two filler openings, fill to level of both openings. The exact amount of oil will depend on the transmission inclination and model. Do not overfill; this will cause oil to be forced out of the transm...
PTO’s,.70 engine speed.) • Constant mesh type PTO required, right side opening. Oil Capacity: • Approx. 28 pints [13.2 liters]. • Optional integral oil pump available. • Integral oil pump is standard on RTO-16908LL and optional on RTO-14908LL. Performance Chart: 2000 1800 1600 1400 1200 1000 800 MPH 0 20 10 30 40 50 60 RPM 2200 Based ...
- 151KB
- 2
This Manual is designed to provide informat ion necessary to service and repair the Eato n Fuller Transmissions listed on the fro nt. How to use this Manual The service procedures have been divided into two sections: In-Vehicle Service Procedures and Transmission Overhaul Procedures—Bench Service.
- 9MB
- 186
cations for Oil Pumps and Coolers below). Oil Coolers operate at maximum cooling efficiency when mounted in a location that receives a direct flow of unheated air, for example, in front of the engine radiator. An Oil Filter can also be used, mounted in-line between the Oil Pump outlet and the Oil Cooler inlet. Applications for Oil Pumps and ...
the transmission can be operated on a 12 degree (21 percent) grade. Anytime the transmission operating angle of 12 de-grees is exceeded for an extended period of time the transmission should be equipped with an oil pump or cooler kit to insure proper lubrication. Note on the chart the effect low oil levels can have on safe operating angles.
People also ask
How do you maintain a Eaton Fuller transmission?
How do you install a transmission fluid filter on an Eaton Fuller?
How do you tighten an Eaton Fuller transmission plug?
Why are Eaton transmission lubricants used in oil cooling?
What is a Eaton Fuller Roadranger transmission?
What tools do you need to reassemble a Eaton Fuller transmission?
May 13, 2024 · Clean the fill plug, then install it in the transmission. Tighten the plug as follows: For an Eaton Fuller transmission with a plug with 3/4-inch pipe threads, tighten the plug 25 to 35 lbf·ft (34 to 47 N·m). For an Eaton Fuller transmission with a plug with 1-1/4-inch pipe threads, tighten the plug 60 to 75 lbf·ft (81 to 102 N·m).
