Search results
- There are two kinds of oil pumps available from Eaton® Fuller® to assist in transmission oil cooling, Auxiliary Coun-tershaft Oil Pumps and the Integral Oil Pump. Auxiliary Oil Pumps are installed externally, in place of the rear bearing cover on the lower countershaft at the right rear of the trans-mission.
www.eaton.com.cn/content/dam/eaton/products/transmissions/vehicle-transmissions/service-manuals/eaton-transmission-oil-pumps-coolers-service-manual-trsm0917-en-us.pdf
People also ask
Can you use additives in Eaton Fuller transmission?
How do I lubricate my Eaton Fuller transmission?
What is a Eaton Fuller Roadranger transmission?
What tools do you need to reassemble a Eaton Fuller transmission?
Why are Eaton transmission lubricants used in oil cooling?
Where can I find a Fuller transmission tool print?
This service manual covers oil pumps and coolers for Fuller Heavy Duty Transmissions by Eaton Cummins.
- Proper Oil Level
- Draining Oil
- Refilling
Make sure oil is level with filler opening. Because you can reach oil with your finger does not mean oil is at the proper level. One inch of oil level is about one gallon of oil.
Drain transmission while oil is warm. To drain oil remove the drain plug at the bottom of the case. Clean the drain plug before reinstalling.
Clean case around filler plug and remove the plug from side of the case. Fill transmission to the level of the filler opening. If the transmission has two filler openings, fill to level of both openings. The exact amount of oil will depend on the transmission inclination and model. Do not overfill; this will cause oil to be forced out of the transm...
Transmission Overhaul Procedures follow the general steps for complete disassembly and then assembly of the Transmission. Note: In some instances the Transmission appearance may be different from the illustrations, but the procedure is the same.
- 9MB
- 186
equipped with an oil pump or cooler kit to insure proper lubrication. Note on the chart the effect low oil levels can have on safe operating angles. Allowing the oil level to fall 1/2” below the filler plug hole reduces the degree of grade by approxi-mately 3 degrees (5.5 percent). Proper Lubrication Levels are Essential! Transmission ...
the transmission can be operated on a 12 degree (21 percent) grade. Anytime the transmission operating angle of 12 de-grees is exceeded for an extended period of time the transmission should be equipped with an oil pump or cooler kit to insure proper lubrication. Note on the chart the effect low oil levels can have on safe operating angles.
There are two kinds of oil pumps available from Eaton® Fuller® to assist in transmission oil cooling, Auxiliary Coun-tershaft Oil Pumps and the Integral Oil Pump. Auxiliary Oil Pumps are installed externally, in place of the rear bearing cover on the lower countershaft at the right rear of the trans-mission.
Eaton-Fuller Transmission RT6613 and RTO6613 Series Parts and Service Manual to assist in identifying your Eaton transmission. If you need any assistance identifying the correct transmission unit for your truck and equipment, contact your Eaton replacement part specialists at Pro Gear and Transmission. Pro Gear Transmission has same day ...
