Search results
The x-ray tube should always be positioned so that the central ray is pointed at the center line on the grid. Grid cut-off is produced with the x-ray tube is moved across the grid lines, or perpendicular to the way the grid lines run in the grid.
On the basis of not deviating from the center line of the X-ray grid, the X-ray center line can be inclined at a certain angle according to the inclination direction of the lead rod, so that the X-ray radiation direction is consistent with the lead.
- Overview of Technical Parameters
- MA
- KVP
- Sid
- Bucky Factor
- Golden Equation
As a technologist you are often faced with the situation where you need to make a change to a protocol but want to keep the exposure on the detector the same. In this scenario it is really important to understand the technical parameters and their influence the exposure, so that when changing parameters you do not end up under-exposing or over-expo...
The tube current and time in the x-ray exam are the parameters that are most frequently changed and you should consider this as your first go-to adjustment in order to change the x-ray exposure without impacting the quality of the exam in other ways. Increasing the tube current is actually just providing more electrons that with smash into the x-ra...
The kVp is the most important technical parameter as it has a very strong dependence on the x-ray exposure (kVp5). This strong dependence on the kVp for the exposure at the image receptor is because of the higher flux and stronger penetration of higher kVp imaging. Additionally, the kVp also changes the inherent contrast in the x-ray images. Since ...
The Source to Image Distance (SID) affects the exposure at the image receptor since the x-ray beam is divergent (i.e. spreading out as it gets further from the x-ray tube). Since the x-rays are spreading out the exposure depends on the SID as 1/SID2 . In our post on the basic x-ray properties we demonstrate how the divergent beam leads to the 1/R2d...
Finally, the Bucky factor is a unitless quantity which is the ratio of the x-ray exposure reaching the grid to the x-ray exposure reaching the image receptor. If no grid is used this definition will lead to a Bucky factor of 1.0. The Bucky factor for grids is dependent upon the grid ratio (grid height: grid spacing) and the kVp. It typically ranges...
Now that we have all pieces we can put these 5 simple relationshipstogether to make what we call the golden equation. You can give it your own cool name too. We just call it the golden equation since it has all of the factors that you need to consider so that as you change one factor you can compensate to keep your exposure constant. Also this is j...
Scatter Removal Grids. The antiscatter grid plays an important role for enhancing image quality in projection radiography by transmitting a majority of primary radiation and selectively rejecting scattered radiation.
Feb 6, 2015 · The purpose of this experiment was to test the alignment of the radiographic grid in the bucky mechanism with respect to the central ray of the x-ray tube. In this experiment, grid misalignment can be detected by analyzing the optical densities of the resultant dot images obtained using a grid alignment tool shown in Figure 3.
On the basis of not deviating from the center line of the x ray grid, the X-ray center line can be tilted at a certain angle according to the tilt direction of the lead bar to make the X-ray radiation direction consistent with the lead bar direction.
People also ask
What does the center line on a X ray grid mean?
Where should the X-ray tube be positioned?
What is a parallel X ray grid?
How do radiographers know the direction of grid lines?
What is a crossed X ray grid?
What happens if you use a grid in a X ray?
X-ray tubes can usually be angled 360 degrees, but most tubes have a stop or detent, which lets the radiographer know when the tube is positioned so the central ray is perpendicular to the bucky tray or the x-ray table top.
