Search results
This Old House contributor Mark Clement demonstrates how to use a jigsaw to easily cut into the center of a board without drilling pilot holes for the blade....
- 2 min
- 104.4K
- This Old House
- When to Use Plunge Cuts
- Safety Considerations For Jigsaws
- Making The Plunge Cut
- More Tips For Clean, Accurate Plunge Cuts
- Troubleshooting Common Plunge Cut Issues
- Maintaining Your Jigsaw
Plunge cuts come in handy for both woodworking and home improvement projects. A few common scenarios where you might use them include the following: 1. Cutting access panels in walls and ceilings 2. Cutting speaker openings for living room and den cabinets 3. Installing recessed light fixtures 4. Making holes for electrical outlets in drywall or pa...
Safety is always first when you make a plunge cut. Put on safety glasses and hearing protection, and clear your work area of any obstacles. You should also clamp the material down to a workbench or set of sawhorses so it won’t move as you cut.
Once you’ve checked your marks, it’s time to get your jigsaw to work. Set the cut depth for the board you’re working with to avoid wearing out the blade. Position the saw near your starting point and tilt it forward so the front edge of the shoe rests on the material. At this point, the blade still isn’t touching the workpiece. Then, start the saw ...
Keep these other tips in mind for the best results with your plunge cuts: 1. Start the plunge cut slightly inside your marked line. This is to account for the blade’s width. 2. When initiating the plunge cut, use a slow-speed setting to stay in control of the tool. 3. Let the blade reach cutting speed before you start the cut. 4. Apply steady, even...
Even experienced woodworkers can encounter challenges when making plunge cuts. Here are a few common problems and solutions:
Once you’re done making your plunge cut, unplug your jigsaw or remove its battery pack. Wipe down dust and debris with either compressed air or a brush. Disconnect the blade and wipe it and the shoe down with a clean cloth. While you’re cleaning, check to see if the blade needs replacement. If you’re noticing it takes more effort to make cuts, if t...
Jan 29, 2014 · Demonstration of how to make a plunge cut into wood with a jigsaw.You forgot the drill to make a starter hole? This technique allows you to use your jigsaw ...
- 3 min
- 145K
- Enduring Charm LLC
Aug 21, 2022 · Step 2: Set the Jigsaw at the Right Position. As mentioned above, you can make a plunge cut sans drilling a pilot hole. You only need to properly position the jigsaw’s shoe front on your workpiece to set the blade aligned or nearly horizontal to your cutline. Press the jigsaw’s baseplate on the board with firmness.
Step By Step Guide To Plunge Cut With Jigsaw. Step 1: Make the necessary measurement and marking for the cutting. Finding a good entry point is very crucial in plunge cutting. Step 2: Securely place the workpiece on the table. Remember to keep enough space under the workpiece so the blade can move freely.
May 11, 2016 · When you need to cut a shape inside a piece of wood, a plunge cut is pretty much your only choice. Typically, you might use a drill with a small bit to bore a hole that you can drop your jigsaw ...
People also ask
Can a jigsaw make a plunge cut?
How to make a plunge cut without drilling a pilot hole?
Can a jigsaw cut a straight line?
How to make a plunge cut?
How to plunge cut wood?
How do you cut wood with a jigsaw?
You can simply plunge cut with the jigsaw. This is a race that goes to the slow and steady. Watch the video closely and follow the instructions. It’s important that you pivot into the work, easing the blade in on the waste side of the line. Move the saw forward at the same time as you’re pivoting into the work.
