Search results
This was the second bridge in the area designed by Calatrava, the first being the James Joyce Bridge, which is further upriver. [ 5 ] Constructed by a "Graham Hollandia Joint Venture", [ 3 ] the main span of the Samuel Beckett Bridge is supported by 31 cable stays from a doubly back-stayed single forward arc tubular tapered spar , with decking provided for four traffic and two pedestrian lanes.
The Samuel Beckett bridge is a cable stayed, steel box girder structure with a span of 123m over the Liffey. Designed by Santiago Calatrava in conjunction with Roughan O’Donovan (Dublin); the bridge was built by Graham Hollandia Joint Venture Contractors. Graham constructed the abutments, river pivot pier and the roadworks.
- Graham Hollandia Joint Venture
- Steel
- Santiago Calatrava
- Cable-stayed (swing)
- Introduction
- Geometry
- Concept
- Structural Design
- Construction Process
- References
The Samuel Beckett Bridge is one of the many bridges that crosses over the River Liffey in Dublin, Ireland. It joins Sir John Rogerson’s Quay on the south side to Guild Street and North Wall Quay in the Docklands area. The bridge was named after Samuel Beckett, Nobel Laureate, to complement the sister bridge, James Joyce, located up stream. It is a...
Cross section of the deck
The width of the bridge is around 27 m, and it has two pedestrian and cycle tracks plus four lanes for vehicles. Two of these lanes can be adapted to accommodate trams in the future. It is a steel multi-cell box girder from which the ribs and steel decking forming the pedestrian and cycle tracks cantilever. The top plate of the box is only 14 mm thick, but it has 12 mm trapezoidal stiffeners every 0.5 m. The back span houses the counterbalance (concrete and steel) and the plates are not stiff...
Cables
The cable-stays are locked coil cables, that is, they are formed by strands arranged in concentric layers about a central one. The front span is supported by 25 cables of 60 mm in diameter set in a ‘harp’ formation. There are 6 stronger cables in the back with a diameter of 145 mm.
Pylon and foundation
Its support consists of a circular concrete pier of varying diameter sitting on a foundation made out of bored concrete piles and a concrete pile cap. The concrete pier has an outer diameter of 8,6 m at the base and 15 m at the top, with a height of 10 m. Inside, there is a 10 m long central steel tube with a diameter of 2,5 m and a plate thickness of 120 mm, which is welded to the deck below the base of the pylon, to transfer the load to the pile cap below. There is a main vertical bearing a...
When the bridge is closed, it sits on a continuous horizontal elastomeric bearing ring on the rim of the support pier, and it is kept into position by two pairs of locking pins at each end, that are inserted into housings cast into the abutments. The expansion joints at each end of the bridge are formed by movable steel boxes, which are controlled ...
This special bridge was designed for two different situations, as it has to resist live loads (traffic and pedestrians) when closed, but it also has to bear its own weight when it’s opened and only supported on the pylon. The worst case of analysis is the opened situation, where forces and deflection of pylon and deck had to be minimized by designi...
The construction started with an installation of a 20 m square AZ46 sheet piled cofferdam, driven to the top of the bedrock (about 3 m deep in the soil), in order to build the foundation. Walers and struts were progressively installed as the cofferdam was dewatered. It was necessary to place concrete as a bottom strut before the cofferdam could be ...
https://www.icevirtuallibrary.com/doi/10.1680/bren.2011.164.3.133 http://www.bridgesofdublin.ie/bridges/samuel-beckett-bridge/design-and-engineering http://dofengineers.com/project/samuel-beckett-bridge/
It is a cable-stayed bridge, whose main structure consists of 25 straps front and 6 rear, with a runway of 124 meters long, 27 meters wide and a single pylon 40 feet tall. The cross section of the board is a box girder with cantilever ribs on each side that can accommodate four lanes of traffic. Its total weight is 5700 tonnes.
- Dublin, Ireland
Nov 29, 2018 · The stunning similarities between Dublin's Samuel Beckett Bridge and New York City's Oculus. ... Spaniard built a bridge between Dublin and New York ... a Troubles museum like the 9/11 one in New ...
Rosie Hackett Bridge. Built 2014. Samuel Beckett Bridge. Built 2009. Ha’penny Bridge. Built 1816. By Use. Road Bridges. Including: West-Link Bridge, Talbot Memorial Bridge, Samuel Beckett Bridge,... Pedestrian Bridges. Including: Seán O’Casey Bridge, Millennium Bridge, Ha’penny Bridge, Farmleigh... Rail Bridges
People also ask
Who built the Samuel Beckett Bridge?
Why is Beckett Bridge named after James Joyce?
How many cable stays does the Samuel Beckett Bridge have?
Why is Beckett Bridge so famous?
Why is Calatrava bridge named after Samuel Beckett?
Who built the Dublin Bridge?
Dillinger Hütte gtS STEELS FOR CONSTRUCTIONAL STEELWORK tHe SAMUel BeCKett CABle-StAYeD BriDge 3937_dihd_fol_cs4.indd 1 01.03.12 17:31 elegAnCe in Steel Irish author Samuel Barclay Beckett was born in Dublin on April 13, 1906.
